Are those little bits of copper sheet in the middle?
they are actually very thin two sided copper-clad board! copper sheets would be better. I was just working with what I had.
you can see that the first quad I made I used curled up resistor leads, but it was so finicky to build that I moved to the PCB material after making a few easy three jack ones.
Yeah I was just gonna say, even strip or perf board would be better that resistor legs!
definitely! also, fun fact, the three way that I built that was just terminal tip to terminal tip just broke like nothing today. Not a good way to do it! all the other are doing fine so far.
Very cool! I make these too, along with other useful little doodads, and usually encapsulate them with heat shrink tubing, check it out:
I’ll be making a few of these, Sugru on top when they’re done.